A&P aircraft electrical systems practice questions
Aircraft Electrical Systems is ACS area AM.II.K of the FAA Airframe (AMA) test, 5-10% of its 100 questions, so roughly 5 to 10 questions (FAA-G-ACS-1, chapter 3). The ACS lists 17 knowledge elements for it (more counting sub-items), and your test report names any you miss by code, like AM.II.K.K1. Below are 6 free original questions from Rivetry's reviewed bank, with the explanation for each.
Last updated · Published by Certloom Learning · How this page was made: written from the official sources listed at the end (read on 2026-11-12); the quiz items come from Rivetry's bank, where every item was solved blind by a second reviewer and disagreements were fixed or dropped.
What does the ACS list for aircraft electrical systems?
Aircraft electrical systems is the applied version of General electricity: how power is generated, regulated, distributed and protected, and how a mechanic troubleshoots it.
| Code | Knowledge element |
|---|---|
| AM.II.K.K1 | Generators, DC generation systems, and DC power distribution systems. |
| AM.II.K.K2 | Alternators, AC generation systems, and AC power distribution systems. |
| AM.II.K.K3 | Starter generators. |
| AM.II.K.K4 | constant speed drive (CSD) and integrated drive generator (IDG) systems and components. |
| AM.II.K.K5 | Voltage regulators and over-volt and overcurrent protection. |
| AM.II.K.K6 | Inverter systems. |
| AM.II.K.K7 | Aircraft wiring sizes, types, selection, installation and circuit protection devices. |
| AM.II.K.K8 | Derating factors in switch selection. |
| AM.II.K.K9 | Aircraft wiring shielding. |
| AM.II.K.K10 | Aircraft lightning protection. |
| AM.II.K.K11 | Instrument or instrument panel removal and installation. |
| AM.II.K.K12 | Aircraft lighting systems. |
| AM.II.K.K13 | Electrical system troubleshooting. |
| AM.II.K.K14 | Soldering preparation, types of solder, and flux usage. |
| AM.II.K.K15 | Aircraft electrical connectors, splices, terminals, and switches. |
| AM.II.K.K16 | Electrical system measurement, adjustment, and testing. |
| AM.II.K.K17 | Aircraft battery troubleshooting and maintenance. |
Source: FAA-S-ACS-1, area AM.II.K, read 2026-11-12. The written test draws on the knowledge elements. The ACS also lists 9 risk management and 20 skill elements, which the examiner checks at the oral and practical (The oral and practical (O&P) test).
How many aircraft electrical systems questions will I get?
The FAA gives this area 5-10% of the AMA test. On 100 questions that is about 5 to 10 (our arithmetic on the FAA range). Rivetry has 55 reviewed items tagged AM.II.K, 6 of them free.
How should I study aircraft electrical systems?
- Start with the generation chain: generators and alternators, voltage regulators, over-voltage and over-current protection, inverters (K1 to K6).
- Wiring selection and circuit protection (K7) mix tables with judgment; learn why size, length and load matter together.
- Use the bus-load workup to turn watts into amps and check against a breaker rating.
- Troubleshooting and measurement (K13, K16) reward a method: confirm the symptom, isolate by section, then measure.
Learn it from FAA-H-8083-31B, then test yourself.
Worked calculations for this area
- Bus load and Watt's law AM.II.K.K1
Free mini quiz: 6 practice questions
6 free AM.II.K questions. These are original Rivetry items from the reviewed bank of 1,792, not FAA test questions. Open each one to check your answer.
AM.II.K.K1 a4-054
On a twin-engine airplane with two paralleled DC generators, one generator carries 80 A while the other carries 20 A. Which circuit is designed to correct this unequal load sharing?
- The equalizing circuit that adjusts both voltage regulators
- The reverse-current relay of the lightly loaded generator
- The current limiter of the heavily loaded generator
Show answer
Answer: A. Paralleled generators share load according to their output voltages, so an equalizing circuit senses the load difference and adjusts each regulator until the loads match. The current limiter acts only when a generator reaches its rated maximum, and the reverse-current relay only prevents back-feeding.
Source: FAA-H-8083-31B, Aircraft Electrical System / paralleling DC generators
AM.II.K.K1 a4-055
Why are critical loads on many aircraft supplied from an essential bus that can be fed by both the generator and the battery?
- So essential equipment receives a higher voltage than nonessential loads
- So the battery can be recharged without any current passing through the main bus
- So critical equipment stays powered by the battery if generation fails
Show answer
Answer: C. Power distribution systems group critical loads on an essential bus so that after a generator failure the battery, or another source, keeps them running while nonessential loads are shed. The essential bus operates at the same system voltage as the other buses.
Source: FAA-H-8083-31B, Aircraft Electrical System / DC power distribution
AM.II.K.K2 a4-057
A light airplane with a completely dead battery is hand-propped and started. The ammeter shows that the alternator never begins charging. What is the most likely reason?
- The alternator field needs battery current for excitation, so no output is produced
- The voltage regulator keeps the alternator offline until the engine reaches cruise rpm
- The dead battery erased the residual magnetism the alternator needs to start
Show answer
Answer: A. Typical light-aircraft alternators have no useful residual magnetism and depend on battery voltage to energize the rotating field. With a dead battery the field is not excited, so the alternator cannot come online. Self-excitation from residual magnetism is a feature of DC generators.
Source: FAA-H-8083-31B, Aircraft Electrical System / alternators
AM.II.K.K2 a4-058
In a brushless AC generator, how does DC field current reach the rotating main field without brushes?
- Exciter AC on the rotor is rectified by diodes turning with the shaft
- It passes through slip rings that ride on carbon brushes at the end of the shaft
- The main field is a permanent magnet, so it needs no field current at all
Show answer
Answer: A. The stationary exciter field induces AC in an exciter armature on the rotor, and rotating rectifiers convert it to DC for the main field, so no brushes or slip rings are needed. A small permanent magnet generator may supply exciter power, but the main field itself is a wound electromagnet.
Source: FAA-H-8083-31B, Aircraft Electrical System / brushless AC generators
AM.II.K.K3 a4-059
Why are starter-generators common on turboprop and small turbine-powered aircraft?
- One unit both starts the engine and then generates power, saving weight
- They produce constant-frequency AC power without needing a constant speed drive
- They have no brushes, so brush wear never needs to be inspected
Show answer
Answer: A. A starter-generator is a DC machine that runs as a motor to start the engine and then switches to generator operation, eliminating a separate starter and its weight. It produces DC, not constant-frequency AC, and it does use brushes, which must be inspected for wear.
Source: FAA-H-8083-31B, Aircraft Electrical System / starter-generators
AM.II.K.K1 a4-053
What is the function of the reverse-current cutout relay in a DC generator system?
- It reverses the generator field polarity whenever residual magnetism is lost
- It opens the generator circuit if generator voltage drops below battery voltage
- It limits generator output current to the maximum on the generator's data plate
Show answer
Answer: B. When generator voltage drops below battery voltage, as at low rpm or shutdown, current would flow back from the battery and motor the generator. The reverse-current relay opens to prevent this. Limiting output current is the job of the current limiter.
Source: FAA-H-8083-31B, Aircraft Electrical System / DC generator control
Rivetry has 1,792 items like these for the General, Airframe and Powerplant tests, timed tests at the FAA length, and a figure bench that works every calculation step by step. Try the sample questions or open the free bench.
More questions
- Should I study General electricity first?
- Yes. This area assumes Ohm's and Watt's law and series-parallel circuits from AM.I.A.
- Are batteries tested here?
- Aircraft battery troubleshooting and maintenance (K17) is listed in this area; the General area covers battery types and hazards.
- Are these the real FAA questions?
- No. The FAA does not publish its live test questions. These are original practice items tagged with the ACS code they practice.
- How many aircraft electrical systems questions does Rivetry have?
- 55 reviewed items, 6 of them free.
Sources
- FAA-S-ACS-1, Aviation Mechanic General, Airframe, and Powerplant Airman Certification Standards (November 1, 2021). FAA. Read 2026-11-12.
- FAA-G-ACS-1, Companion Guide to the Aviation Mechanic ACS (with Changes 1 and 2, September 2024). FAA. Read 2026-11-12.
- FAA-H-8083-31B, Aviation Maintenance Technician Handbook: Airframe. FAA. Used to write the practice items 2026-11-12.
Related guides
General study information, not legal advice. Rules and FAA documents change; confirm with the FAA (faa.gov, your Flight Standards District Office) before you act.