A&P ice and rain control systems practice questions
Ice and Rain Control Systems is ACS area AM.II.L of the FAA Airframe (AMA) test, 5-10% of its 100 questions, so roughly 5 to 10 questions (FAA-G-ACS-1, chapter 3). The ACS lists 7 knowledge elements for it (more counting sub-items), and your test report names any you miss by code, like AM.II.L.K1. Below are 5 sample original questions from Rivetry's reviewed bank, with the explanation for each.
Last updated · Published by Certloom Learning · How this page was made: written from the official sources listed at the end (read on 2026-11-14); the quiz items come from Rivetry's bank, where every item was solved blind by a second reviewer and disagreements were fixed or dropped.
What does the ACS list for ice and rain control systems?
Ice and rain control covers why ice forms and what it does, how it is detected, anti-ice systems that prevent it, de-ice systems that remove it, and rain control on windshields.
| Code | Knowledge element |
|---|---|
| AM.II.L.K1 | Aircraft icing causes/effects. |
| AM.II.L.K2 | Ice detection systems. |
| AM.II.L.K3 | Aircraft and powerplant anti-ice systems and components. |
| AM.II.L.K4 | De-ice systems and components. |
| AM.II.L.K5 | Wiper blade, chemical, and pneumatic bleed air rain control systems. |
| AM.II.L.K6 | Anti-icing and de-icing system maintenance. |
| AM.II.L.K7 | Environmental conditions that degrade vision. |
Source: FAA-S-ACS-1, area AM.II.L, read 2026-11-14. The written test draws on the knowledge elements. The ACS also lists 3 risk management and 9 skill elements, which the examiner checks at the oral and practical (The oral and practical (O&P) test).
How many ice and rain control systems questions will I get?
The FAA gives this area 5-10% of the AMA test. On 100 questions that is about 5 to 10 (our arithmetic on the FAA range). Rivetry has 33 reviewed items tagged AM.II.L, 4 of them free.
How should I study ice and rain control systems?
- Separate anti-ice, which keeps ice from forming (often with heat), from de-ice, which removes ice after it forms (often with pneumatic boots) (K3, K4).
- Pneumatic boots inflate in sequence to crack the ice. Learn how they are cleaned and inspected (S2, S3).
- Electrically heated pitot tubes and windshields: troubleshooting and operational checks are skill elements (S4, S6).
- Deicing fluid storage and the cleaners used on heated windshields are risk elements (R2, R3).
Learn it from FAA-H-8083-31B, then test yourself.
What could the practical ask me to do?
These are the 9 skill elements the ACS lists for AM.II.L. Any of them can become a project at the oral and practical, done with the references the examiner provides (Practical test projects by ACS area).
- S1 Inspect and operationally check pitot-static anti-ice system.
- S2 Inspect and operationally check deicer boot.
- S3 Clean a pneumatic deicer boot.
- S4 Troubleshoot an electrically-heated pitot system.
- S5 Inspect thermal anti-ice systems.
- S6 Inspect and operationally check an electrically-heated windshield.
- S7 Locate and explain the procedures for inspecting an electrically-operated windshield wiper system.
- S8 Locate and explain the procedures for replacing blades on a windshield wiper system.
- S9 Locate and explain the procedures for inspecting a pneumatic rain removal system.
The risk management elements for this area: System testing or maintenance (R1); Storage and handling of deicing fluids (R2); Selection and use of cleaning materials for heated windshields (R3).
Free mini quiz: 5 practice questions
5 AM.II.L questions: 4 from the app's free set and 1 more as a sample. These are original Rivetry items from the reviewed bank of 1,792, not FAA test questions. Open each one to check your answer.
AM.II.L.K1 a5-002
During an early-morning preflight, a mechanic finds a thin layer of frost on the upper surface of a wing. The pilot says it is too thin to matter. What is the correct position?
- Remove it before flight; frost roughens the surface and can reduce lift
- Leave it; frost thinner than about 1/8 inch has no aerodynamic effect
- Leave it; frost on the wing will blow off during the takeoff roll
Show answer
Answer: A. Even thin frost roughens the upper wing surface enough to disturb the airflow, reduce lift, and raise the stall speed, so it must be removed before flight. It cannot be relied on to blow off during the takeoff roll, which is when the wing needs full lift.
Source: FAA-H-8083-31B, Ice and Rain Protection / Effects of icing; frost
AM.II.L.K1 a5-003
Why is ice on a wing leading edge more dangerous than its weight alone would suggest?
- Its added weight moves the center of gravity aft of the rear limit
- It blocks the pitot-static ports located along the wing leading edge
- It changes the airfoil shape, reducing lift and increasing drag
Show answer
Answer: C. Leading-edge ice deforms the airfoil, disrupting airflow so lift drops, drag rises, and the stall occurs at a higher speed. The added weight matters too, but the shape change is the bigger hazard; a modest ice load does not by itself push the CG out of limits.
Source: FAA-H-8083-31B, Ice and Rain Protection / Effects of icing
AM.II.L.K2 a5-004
A turbine airplane uses a vibrating-probe ice detector mounted in the airstream. How does this detector sense that ice is forming?
- Ice on the probe lowers its vibrating frequency below a set point
- Ice on the probe raises the electrical resistance of its heater
- Ice blocks a small port and changes the pressure inside the probe
Show answer
Answer: A. The probe is driven to vibrate at a fixed frequency; ice building up on it adds mass and lowers that frequency, which triggers the ice signal. The probe heater then melts the ice so it can sense again. It does not work by measuring heater resistance or a blocked pressure port.
Source: FAA-H-8083-31B, Ice and Rain Protection / Ice detection systems
AM.II.L.K1 a5-001
Supercooled water drops that are relatively large strike a wing leading edge, spread out, and freeze slowly as they flow aft. What type of ice does this form?
- Rime ice, which is rough, milky, and brittle
- Frost, which forms as a thin, feathery crystalline deposit on the skin
- Clear (glaze) ice, which is hard, heavy, and hard to remove
Show answer
Answer: C. Large supercooled drops do not freeze instantly; they flow back before freezing and form clear (glaze) ice that is dense and bonds tightly. Rime ice comes from small drops that freeze on impact, trapping air and giving a rough, milky deposit.
Source: FAA-H-8083-31B, Ice and Rain Protection / Formation and types of ice
AM.II.L.K2 a5-005
A crew writes up that during night flight they could not see whether ice was building on the wing leading edges. Which equipment should the mechanic check first?
- The wingtip navigation (position) lights
- The wing ice inspection lights
- The anti-collision strobe lights on the wingtips
Show answer
Answer: B. Wing inspection lights, usually mounted on the fuselage or nacelle, are aimed at the leading edges so the crew can see ice accumulation at night. Navigation and strobe lights are on the wingtips and point outward, so they do not illuminate the leading edge for an ice check.
Source: FAA-H-8083-31B, Ice and Rain Protection / Ice detection; wing inspection lights
Rivetry has 1,792 items like these for the General, Airframe and Powerplant tests, timed tests at the FAA length, and a figure bench that works every calculation step by step. Try the sample questions or open the free bench.
More questions
- Can I clean a boot with any solvent?
- No. Use the cleaner the manufacturer approves. Cleaning a pneumatic deicer boot is skill element S3.
- Are engine inlets covered here?
- Powerplant anti-ice appears here (K3) and again in turbine engine air systems (AM.III.K.K8).
- Are these the real FAA questions?
- No. The FAA does not publish its live test questions. These are original practice items tagged with the ACS code they practice.
- How many ice and rain control systems questions does Rivetry have?
- 33 reviewed items, 4 of them free.
Sources
- FAA-S-ACS-1, Aviation Mechanic General, Airframe, and Powerplant Airman Certification Standards (November 1, 2021). FAA. Read 2026-11-14.
- FAA-G-ACS-1, Companion Guide to the Aviation Mechanic ACS (with Changes 1 and 2, September 2024). FAA. Read 2026-11-14.
- FAA-H-8083-31B, Aviation Maintenance Technician Handbook: Airframe. FAA. Used to write the practice items 2026-11-14.
Related guides
General study information, not legal advice. Rules and FAA documents change; confirm with the FAA (faa.gov, your Flight Standards District Office) before you act.