A&P aircraft fuel systems practice questions
Aircraft Fuel Systems is ACS area AM.II.J of the FAA Airframe (AMA) test, 5-10% of its 100 questions, so roughly 5 to 10 questions (FAA-G-ACS-1, chapter 3). The ACS lists 9 knowledge elements for it (more counting sub-items), and your test report names any you miss by code, like AM.II.J.K1. Below are 5 sample original questions from Rivetry's reviewed bank, with the explanation for each.
Last updated · Published by Certloom Learning · How this page was made: written from the official sources listed at the end (read on 2026-11-14); the quiz items come from Rivetry's bank, where every item was solved blind by a second reviewer and disagreements were fixed or dropped.
What does the ACS list for aircraft fuel systems?
Aircraft fuel systems covers system types, tanks and cells, pumps, filters and valves, fuel transfer and jettison, quantity indication and maintenance. Contamination and fuel tank entry are the safety themes.
| Code | Knowledge element |
|---|---|
| AM.II.J.K1 | Fuel system types. |
| AM.II.J.K2 | Fuel system components, including filters and selector valves. |
| AM.II.J.K3 | Aircraft fuel tanks/cells |
| AM.II.J.K4 | Fuel flow. |
| AM.II.J.K5 | Fuel transfer, fueling, and defueling. |
| AM.II.J.K6 | Fuel jettisoning/dump systems. |
| AM.II.J.K7 | Characteristics of fuel types. |
| AM.II.J.K8 | Fuel system maintenance and inspection. |
| AM.II.J.K9 | Fuel quantity indication. |
Source: FAA-S-ACS-1, area AM.II.J, read 2026-11-14. The written test draws on the knowledge elements. The ACS also lists 5 risk management and 18 skill elements, which the examiner checks at the oral and practical (The oral and practical (O&P) test).
How many aircraft fuel systems questions will I get?
The FAA gives this area 5-10% of the AMA test. On 100 questions that is about 5 to 10 (our arithmetic on the FAA range). Rivetry has 44 reviewed items tagged AM.II.J, 5 of them free.
How should I study aircraft fuel systems?
- Know the tank types: welded or riveted metal tanks, bladder cells and integral (wet wing) tanks (K3, S2).
- Learn gravity-feed and pump-feed systems and where the boost pumps, selector valves and strainers sit (K1, K2).
- Contamination control: sump drains at the low points, water checks and the main strainer (K8, S7, S8).
- Entering a fuel tank needs purging and atmosphere checks; it is a named risk element (R4).
Learn it from FAA-H-8083-31B, then test yourself.
What could the practical ask me to do?
These are the 18 skill elements the ACS lists for AM.II.J. Any of them can become a project at the oral and practical, done with the references the examiner provides (Practical test projects by ACS area).
- S1 Inspect, check, troubleshoot, or repair a fuel system.
- S2 Inspect a metal, bladder, or integral fuel tank.
- S3 Troubleshoot and repair aircraft fuel system.
- S4 Inspect a fuel selector valve.
- S5 Inspect and check manually-operated fuel valves for proper operation and leaks.
- S6 Troubleshoot a fuel valve problem.
- S7 Drain fuel system sump(s).
- S8 Service a fuel system strainer.
- S9 Inspect a fuel quantity indicating system.
- S10 Locate fuel system operating instructions.
- S11 Locate fuel system inspection procedures.
- S12 Locate fuel system crossfeed procedures.
- S13 Locate fuel system required placards.
- S14 Locate fuel system defueling procedures.
- S15 Troubleshoot fuel pressure warning system.
- S16 Locate troubleshooting procedures for fuel temperature systems.
- S17 Remove and install a fuel quantity transmitter.
- S18 Troubleshoot fuel quantity indicating system.
The risk management elements for this area: Fuel system maintenance (R1); Fuel system contamination (R2); Fuel spills (R3); Fuel system maintenance requiring fuel tank entry (R4); Defueling aircraft (R5).
Free mini quiz: 5 practice questions
5 AM.II.J questions: 5 from the app's free set and 0 more as a sample. These are original Rivetry items from the reviewed bank of 1,792, not FAA test questions. Open each one to check your answer.
AM.II.J.K1 a4-024
The left engine of a twin with one main tank per engine has been shut down in flight. The pilot wants to burn fuel from the left tank in the right engine to keep the airplane balanced. Which feature allows this?
- The fuel jettison system
- The crossfeed system
- The tank vent interconnect
Show answer
Answer: B. A crossfeed valve and line let either engine draw from the opposite side's tank, which is used after an engine failure to keep fuel balanced. Jettisoning dumps fuel overboard rather than feeding an engine, and vent lines carry only air and vapor.
Source: FAA-H-8083-31B, Aircraft Fuel System / multiengine fuel systems
AM.II.J.K1 a4-025
On a multiengine transport airplane, why is each engine normally fed by its own tank and pumps, with crossfeed used only when selected?
- So that one failed fuel system component cannot cause more than one engine to lose power
- Because crossfeed lines are too small to supply an engine at takeoff power
- Because fuel from a single tank cannot be metered accurately to two engines at once
Show answer
Answer: A. 14 CFR 25.953 requires a fuel system arrangement in which the failure of any one component (other than a tank) will not cause loss of power on more than one engine. Independent tank-to-engine feed provides that isolation. Crossfeed lines are sized to supply an engine when they are opened.
Source: 14 CFR 25.953; FAA-H-8083-31B, Aircraft Fuel System / multiengine fuel systems
AM.II.J.K2 a4-026
Where is the main fuel strainer (gascolator) of a light airplane fuel system normally located, and why?
- At the carburetor inlet, so fuel is filtered just before it is metered
- At the highest point of the system, so vapor and debris can be vented together
- At the system's low point, so water and sediment collect where they can be drained
Show answer
Answer: C. The main strainer is placed at the low point between the tanks and the engine so water and sediment settle in its bowl, where the sump drain removes them. The carburetor has its own small inlet screen, but it is not the main strainer and has no drain.
Source: FAA-H-8083-31B, Aircraft Fuel System / fuel strainers and filters
AM.II.J.K2 a4-027
When inspecting a fuel selector valve, what should a mechanic check in addition to leakage?
- That each position has a positive detent and lines up with its placard markings
- That the handle turns freely between positions with no detent resistance
- That the OFF position is spring-loaded so it cannot remain selected
Show answer
Answer: A. Selector valves need a positive detent at each position so the pilot can feel when a tank is fully selected, and the handle must agree with the placard. A valve that turns freely could stop between ports and starve the engine, and OFF is a normal detented position.
Source: FAA-H-8083-31B, Aircraft Fuel System / fuel selector valves
AM.II.J.K1 a4-023
Why does a typical carbureted high-wing light airplane often have no fuel pump in its fuel system?
- The carburetor float chamber produces enough suction to draw fuel from the tanks
- Fuel pumps are not permitted in systems that feed from wing tanks
- The tanks sit above the carburetor, so gravity alone supplies enough fuel pressure
Show answer
Answer: C. In a gravity-feed system the wing tanks are well above the carburetor, and the head of fuel provides the pressure needed to keep the float chamber full. A carburetor does not pull fuel from the tanks by suction, and low-wing airplanes with wing tanks routinely use pumps.
Source: FAA-H-8083-31B, Aircraft Fuel System / gravity-feed systems
Rivetry has 1,792 items like these for the General, Airframe and Powerplant tests, timed tests at the FAA length, and a figure bench that works every calculation step by step. Try the sample questions or open the free bench.
More questions
- What is fuel jettison?
- A system on some aircraft that dumps fuel in flight to reach a safe landing weight (K6).
- Is fuel quantity indication here or under instruments?
- Both. It is K9 here and K11 in aircraft instrument systems, so expect it from either side.
- Are these the real FAA questions?
- No. The FAA does not publish its live test questions. These are original practice items tagged with the ACS code they practice.
- How many aircraft fuel systems questions does Rivetry have?
- 44 reviewed items, 5 of them free.
Sources
- FAA-S-ACS-1, Aviation Mechanic General, Airframe, and Powerplant Airman Certification Standards (November 1, 2021). FAA. Read 2026-11-14.
- FAA-G-ACS-1, Companion Guide to the Aviation Mechanic ACS (with Changes 1 and 2, September 2024). FAA. Read 2026-11-14.
- FAA-H-8083-31B, Aviation Maintenance Technician Handbook: Airframe. FAA. Used to write the practice items 2026-11-14.
Related guides
General study information, not legal advice. Rules and FAA documents change; confirm with the FAA (faa.gov, your Flight Standards District Office) before you act.