A&P engine electrical systems practice questions
Engine Electrical Systems is ACS area AM.III.F of the FAA Powerplant (AMP) test, 5-15% of its 100 questions, so roughly 5 to 15 questions (FAA-G-ACS-1, chapter 3). The ACS lists 10 knowledge elements for it (more counting sub-items), and your test report names any you miss by code, like AM.III.F.K1. Below are 5 sample original questions from Rivetry's reviewed bank, with the explanation for each.
Last updated · Published by Certloom Learning · How this page was made: written from the official sources listed at the end (read on 2026-11-14); the quiz items come from Rivetry's bank, where every item was solved blind by a second reviewer and disagreements were fixed or dropped.
What does the ACS list for engine electrical systems?
Engine electrical systems covers generators, alternators and starter generators, voltage regulation and protection, AC and DC generation, wire sizing, paralleling, and the constant speed drives behind AC generators.
| Code | Knowledge element |
|---|---|
| AM.III.F.K1 | Generators. |
| AM.III.F.K2 | Alternators. |
| AM.III.F.K3 | Starter generators. |
| AM.III.F.K4 | Voltage regulators and overvoltage and overcurrent protection. |
| AM.III.F.K5 | DC generation systems. |
| AM.III.F.K6 | AC generation systems. |
| AM.III.F.K7 | The procedure for locating the correct electrical cable/wire size needed to fabricate a cable/wire. |
| AM.III.F.K8 | The purpose and procedure for paralleling a dual-generator electrical system. |
| AM.III.F.K9 | CSD and IDG systems and components. |
| AM.III.F.K10 | Engine electrical wiring, switches, and protective devices. |
Source: FAA-S-ACS-1, area AM.III.F, read 2026-11-14. The written test draws on the knowledge elements. The ACS also lists 4 risk management and 15 skill elements, which the examiner checks at the oral and practical (The oral and practical (O&P) test).
How many engine electrical systems questions will I get?
The FAA gives this area 5-15% of the AMP test. On 100 questions that is about 5 to 15 (our arithmetic on the FAA range). Rivetry has 45 reviewed items tagged AM.III.F, 5 of them free.
How should I study engine electrical systems?
- Know how DC generators and alternators differ in producing and rectifying current, and how each is regulated (K1, K2, K4).
- Paralleling a dual-generator system shares the load, so the outputs must be matched (K8).
- A CSD or IDG turns the AC generator at a constant speed so the frequency stays constant (K9).
- Wire size depends on current, run length and allowable voltage drop, read from charts such as those in AC 43.13-1B (K7).
Learn it from FAA-H-8083-32B, then test yourself.
What could the practical ask me to do?
These are the 15 skill elements the ACS lists for AM.III.F. Any of them can become a project at the oral and practical, done with the references the examiner provides (Practical test projects by ACS area).
- S1 Inspect engine electrical wiring, switches, and protective devices.
- S2 Determine suitability of a replacement component by part number.
- S3 Replace an engine-driven generator or alternator.
- S4 Inspect an engine-driven generator or alternator in accordance with manufacturer’s instructions.
- S5 Troubleshoot an aircraft electrical generating system.
- S6 Remove and install an engine direct-drive electric starter.
- S7 Troubleshoot a direct-drive electric starter system.
- S8 Inspect an electrical system cable.
- S9 Determine wire size for engine electrical system.
- S10 Repair a broken engine electrical system wire.
- S11 Replace a wire bundle lacing.
- S12 Troubleshoot an electrical system using a schematic or wiring diagram.
- S13 Fabricate a bonding jumper.
- S14 Inspect a turbine engine starter generator.
- S15 Inspect engine electrical connectors.
The risk management elements for this area: Polarity when performing electrical system maintenance (R1); Actions in response to a warning or caution annunciator light (R2); Maintenance on energized aircraft circuits/systems (R3); Routing and security of wiring near flammable fluid lines (R4).
Free mini quiz: 5 practice questions
5 AM.III.F questions: 5 from the app's free set and 0 more as a sample. These are original Rivetry items from the reviewed bank of 1,792, not FAA test questions. Open each one to check your answer.
AM.III.F.K1 p2-072
After installing new brushes in a DC generator, a mechanic must seat them to the curve of the commutator. What should be used?
- Emery cloth drawn under the brush
- No. 000 sandpaper drawn under the brush
- A file to shape the face of the brush
Show answer
Answer: B. Fine sandpaper wrapped around the commutator and drawn under the brush shapes its face to the curve. Emery cloth must not be used because its metallic abrasive particles can lodge in the commutator and cause shorts, and filing cannot match the curve accurately.
Source: FAA-H-8083-31B, Aircraft Electrical System / Generator maintenance, brushes
AM.III.F.K1 p2-073
A newly overhauled DC generator is installed with correct wiring but produces no voltage. What is a likely fix?
- Reverse the armature leads at the generator terminals
- Raise the voltage regulator's output setting
- Flash the field to restore residual magnetism
Show answer
Answer: C. A self-excited generator needs residual magnetism in its field poles to start building voltage; after overhaul it may be lost, and briefly applying battery current to the field restores it. Reversing leads would reverse polarity, and the regulator cannot raise voltage that never builds.
Source: FAA-H-8083-31B, Aircraft Electrical System / Generator maintenance, flashing the field
AM.III.F.K2 p2-074
A light airplane with an alternator has a completely dead battery. After a hand-propped start, the alternator produces no output. Why?
- The alternator field needs battery current; it cannot self-excite
- The alternator needs a higher rpm than the engine reaches on the ground
- The rectifier diodes are damaged whenever battery voltage falls to zero
Show answer
Answer: A. An aircraft alternator's rotor field is supplied from the bus through the regulator, so with no battery voltage there is no field current and no output. Alternators produce output even at idle, and a dead battery does not by itself damage the diodes.
Source: FAA-H-8083-32B, Engine Ignition and Electrical Systems / Alternators
AM.III.F.K2 p2-075
How is the three-phase AC produced in a light aircraft alternator changed to DC for the bus?
- By a commutator and brushes, as in a DC generator armature
- By six diodes forming a three-phase full-wave rectifier
- By a separate rotary inverter mounted on the engine firewall
Show answer
Answer: B. The stator output passes through a six-diode rectifier bridge built into the alternator to make DC. The alternator's brushes ride on slip rings that only feed the rotor field, and an inverter converts DC to AC, not the reverse.
Source: FAA-H-8083-32B, Engine Ignition and Electrical Systems / Alternators
AM.III.F.K1 p2-071
In an aircraft DC generator, what part changes the alternating current induced in the armature coils into direct current at the output?
- The commutator
- The slip rings
- The field windings
Show answer
Answer: A. The commutator segments reverse the armature coil connections to the brushes each half turn, so the output stays in one direction. Slip rings carry current to or from a rotor without rectifying it, and the field windings only make the magnetic field.
Source: FAA-H-8083-32B, Engine Ignition and Electrical Systems / DC generators
Rivetry has 1,792 items like these for the General, Airframe and Powerplant tests, timed tests at the FAA length, and a figure bench that works every calculation step by step. Try the sample questions or open the free bench.
More questions
- Is the starter generator covered?
- Yes, as K3. It is common on turboprops and small turbines.
- Why is polarity a risk?
- Reversed polarity can damage components; it is risk element R1.
- Are these the real FAA questions?
- No. The FAA does not publish its live test questions. These are original practice items tagged with the ACS code they practice.
- How many engine electrical systems questions does Rivetry have?
- 45 reviewed items, 5 of them free.
Sources
- FAA-S-ACS-1, Aviation Mechanic General, Airframe, and Powerplant Airman Certification Standards (November 1, 2021). FAA. Read 2026-11-14.
- FAA-G-ACS-1, Companion Guide to the Aviation Mechanic ACS (with Changes 1 and 2, September 2024). FAA. Read 2026-11-14.
- FAA-H-8083-32B, Aviation Maintenance Technician Handbook: Powerplant. FAA. Used to write the practice items 2026-11-14.
Related guides
General study information, not legal advice. Rules and FAA documents change; confirm with the FAA (faa.gov, your Flight Standards District Office) before you act.