A&P water and waste systems practice questions
Water and Waste Systems is ACS area AM.II.O of the FAA Airframe (AMA) test, 5-10% of its 100 questions, so roughly 5 to 10 questions (FAA-G-ACS-1, chapter 3). The ACS lists 3 knowledge elements for it (more counting sub-items), and your test report names any you miss by code, like AM.II.O.K1. Below are 5 sample original questions from Rivetry's reviewed bank, with the explanation for each.
Last updated · Published by Certloom Learning · How this page was made: written from the official sources listed at the end (read on 2026-11-14); the quiz items come from Rivetry's bank, where every item was solved blind by a second reviewer and disagreements were fixed or dropped.
What does the ACS list for water and waste systems?
Water and waste systems is the smallest Airframe area: potable water components and operation, lavatory waste systems, and their inspection and servicing. It has three knowledge elements and still carries 5 to 10 percent of the test.
| Code | Knowledge element |
|---|---|
| AM.II.O.K1 | Potable water system components and operation. |
| AM.II.O.K2 | Lavatory waste system components and operation. |
| AM.II.O.K3 | Inspection and servicing requirements for water and waste systems. |
Source: FAA-S-ACS-1, area AM.II.O, read 2026-11-14. The written test draws on the knowledge elements. The ACS also lists 1 risk management and 2 skill elements, which the examiner checks at the oral and practical (The oral and practical (O&P) test).
How many water and waste systems questions will I get?
The FAA gives this area 5-10% of the AMA test. On 100 questions that is about 5 to 10 (our arithmetic on the FAA range). Rivetry has 20 reviewed items tagged AM.II.O, 2 of them free.
How should I study water and waste systems?
- Learn the potable water path: tank, pressurization, distribution, heaters and drains (K1).
- Lavatory waste systems come as recirculating and vacuum types; learn how each works and is serviced (K2).
- Servicing lavatory waste needs the right safety equipment and PPE (R1).
- Know the inspection and servicing requirements for both systems (K3).
Learn it from FAA-H-8083-31B, then test yourself.
What could the practical ask me to do?
These are the 2 skill elements the ACS lists for AM.II.O. Any of them can become a project at the oral and practical, done with the references the examiner provides (Practical test projects by ACS area).
- S1 Locate and explain the procedures for servicing a lavatory waste system.
- S2 Locate and explain the procedures for servicing a potable water system.
The risk management elements for this area: Servicing lavatory waste systems, including use of safety equipment (R1).
Free mini quiz: 5 practice questions
5 AM.II.O questions: 2 from the app's free set and 3 more as a sample. These are original Rivetry items from the reviewed bank of 1,792, not FAA test questions. Open each one to check your answer.
AM.II.O.K1 a5-072
Why are electric heaters installed on some potable water lines, service panel fittings, and drain masts?
- To keep water from freezing in areas exposed to cold
- To sterilize the water as it passes through the lines
- To warm the water for passenger use at the faucets
Show answer
Answer: A. Lines, fill and drain fittings, and drain masts in unheated areas or near the skin can freeze at altitude or on a cold ramp, so they are wrapped with heater tape or blankets. Heat for washing is supplied by separate water heaters under the sinks, and these line heaters do not sterilize water.
Source: FAA-H-8083-31B, Water and Waste Systems / Potable water systems; freeze protection
AM.II.O.K1 a5-071
On a typical transport airplane, how is potable water delivered under pressure to the galley and lavatory faucets?
- Gravity flow from a header tank mounted above the cabin ceiling
- Air pressure on the tank from bleed air or a compressor
- A hydraulic-driven pump installed at each galley and lavatory
Show answer
Answer: B. Most airliners pressurize the potable water tank with air from the pneumatic (bleed) system or from a dedicated air compressor, which pushes water through the distribution lines. Gravity alone cannot reach outlets around the cabin, and hydraulic pumps are not used to move potable water.
Source: FAA-H-8083-31B, Water and Waste Systems / Potable water systems
AM.II.O.K1 a5-073
On many transport airplanes, where does used water from the lavatory sinks (gray water) go?
- Back into the potable water tank through a filter
- Overboard through a heated drain mast
- Into the toilet's flush water reservoir for reuse
Show answer
Answer: B. Gray water from sinks is commonly drained overboard through heated drain masts that keep the outlet from freezing. Returning used water to the potable tank would contaminate it. Toilet waste is handled separately in the vacuum or recirculating waste system.
Source: FAA-H-8083-31B, Water and Waste Systems / Drain masts
AM.II.O.K1 a5-074
What protects a point-of-use lavatory water heater from damage if its normal temperature control fails?
- An overheat thermal switch that cuts power when the water gets too hot
- A pressure relief valve that opens to vent hot water and cool the heater
- Nothing, since the flowing water always keeps the element from overheating
Show answer
Answer: A. Lavatory water heaters have a thermostat for normal control and an independent overheat protection that removes power if the thermostat fails. A pressure relief device does not by itself stop the heating element. Water does not always flow, so a heater could overheat without protection.
Source: FAA-H-8083-31B, Water and Waste Systems / Potable water systems; water heaters
AM.II.O.K2 a5-075
At cruise altitude, what moves waste from a vacuum toilet bowl to the waste tank?
- The pressure difference between the cabin and the outside air
- Gravity, because the waste tank sits below the toilet in the aft hold
- An electric macerator pump built into each toilet bowl assembly
Show answer
Answer: A. The waste tank is vented overboard, so at altitude the higher cabin pressure pushes waste through the line when the flush valve opens. On the ground and at low altitude, where that differential is too small, a vacuum blower supplies the suction. Gravity alone cannot move waste through long horizontal lines.
Source: FAA-H-8083-31B, Water and Waste Systems / Vacuum lavatory systems
Rivetry has 1,792 items like these for the General, Airframe and Powerplant tests, timed tests at the FAA length, and a figure bench that works every calculation step by step. Try the sample questions or open the free bench.
More questions
- Are vacuum toilets tested?
- Lavatory waste system components and operation are K2, and the FAA Airframe handbook covers vacuum systems.
- Is such a small area worth studying?
- Yes. Every area carries at least 5 percent of the 100-question AMA test, so even this one can be 5 or more questions.
- Are these the real FAA questions?
- No. The FAA does not publish its live test questions. These are original practice items tagged with the ACS code they practice.
- How many water and waste systems questions does Rivetry have?
- 20 reviewed items, 2 of them free.
Sources
- FAA-S-ACS-1, Aviation Mechanic General, Airframe, and Powerplant Airman Certification Standards (November 1, 2021). FAA. Read 2026-11-14.
- FAA-G-ACS-1, Companion Guide to the Aviation Mechanic ACS (with Changes 1 and 2, September 2024). FAA. Read 2026-11-14.
- FAA-H-8083-31B, Aviation Maintenance Technician Handbook: Airframe. FAA. Used to write the practice items 2026-11-14.
Related guides
General study information, not legal advice. Rules and FAA documents change; confirm with the FAA (faa.gov, your Flight Standards District Office) before you act.